Interview questions for Tablet compression
Commonly asked interview questions for
Tablet compression are.
- What is Material of construction of turret ?
- How many parts is Turret divided into ?

Interview questions
- What is limit of Friability in IP and USP ?
- What is limit of Weight variation in IP and USP ?
- Why the samples of Initial, Middle and End are withdrawn in compression stage ?
- What are the Equipment’s required to Install the Dies ?
- What are the Different types of Keys in tablet press punches ?
- What is Double impression problem in tablet press ?
- Does double Impression problems occurs in Round as well as Shaped punches ?
- How is Force feeder related to tablet capping problem ?
- What is Tablet Flashing problem ?
- Why the sticking problem is reduced when we polish punches and than again regenerates after few cycles of tabletting ?
- How is capping problem is related to fines in granules ?
- How is Fill cam related to overweight tablets ?

Interview questions
- What is Bakelite relief in tablet tooling ?
- What is Tapered dies in tablet tooling ?
- What is importance of lower punch seals in tablet press ?
- What is importance of dust cups in tablet press ?
- What is the procedure to clean the Dust cups ?
- What are Bellows ?
- What are the positions on punches where Dust cups could be installed ?
- What factors are attributed to Tablet capping ?
- What is the cause which interrelates Capping and Lamination ?
Comments
Post a Comment